Then press any of the remote key (Or which one your want to use), the on-board LED indicator will flash 5 times to inform that the setting of toggle mode is successful. Press the learning key on the Receiver Switch Module board 2 times.The ON-board Led indicator will Flash simultaneously. Then press any of the remote key (Or which one your want to use), the on-board LED indicator will flash 5 times to inform that the setting of momentary mode is successful. Press the learning key on the Receiver Switch Module board once, The ON-board Led indicator will Flash simultaneously. ( if the LED indicator on the board doesn’t Flash, Please check the Power Supply status, make it right, and try more times) Press the learning key on the Receiver Switch Module board 8 times, then wait for the LED indicator on the board flash for 7 times, the existing data are deleted successfully. How to Delete the existing remote controls data? Press and hold one key->ON Release the key->OFF(after 5 seconds, or 10 seconds, or 15 seconds, 3 ways of the time delay can be chosen) Press one Key once->ON Press another key once->OFF Press one Key->ON Press the same key again->OFF Press and hold one key->ON Release the key->OFF You can set the Remote Control to operate in 4 modes: Working mode: Momentary, Toggle, Latching Time delay (5s ,10s ,15s )Īdditional remotes can be codeded and added to this module see MOD0215 Support remote type: Learning code, Fixed code(Rolling code can be design)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |